igos_bond

Simple Steps

Filling restoration with composite resin cured by light

Application
1. Application

Apply iGOS-BOND on whole inside of dried cavity and leave for 20 sec.

Air-blowing
2. Air-blowing

Perform air-blowing sufficiently with a vacuuming device until the liquid surface doesn’t move for 5 sec. or more with strong pressure.

iGOS BOND Line-up set
3. Light Curing

Light cure with a dental light curing unit with light intensity of 300 mW/cm2 or over for 10 sec. or more.

Repairing fracture or wear of crown restorations made of alloys, zirconia ceramics, dental porcelain, or resin material containing inorganic fillers.

iGOS BOND Line-up set
1. Roughening, Washing and Drying of Adherend Surface

Roughen surface with a diamond point, then wash with water and dry

iGOS BOND Line-up set
2. Applying Multi Primer Liquid and Drying

After washing and drying, apply Multi Primer Liquid immediately and air-blow.

iGOS BOND Line-up set
3. Applying iGOS-BOND

Roughen surface with a diamond point, then wash with water and dry

iGOS BOND Line-up set
4. Air-blowing

Perform air-blowing sufficiently with a vacuuming device until the liquid surface doesn’t move approximately 5 sec. or more with strong pressure.

iGOS BOND Line-up set
5. Light cure with a dental light curing unit with light intensity of 300 mW/cm2 or over for 10 sec. or more.

Light cure with a dental light curing unit with light intensity of 300 mW/cm2 or over for 10 sec. or more.

Support

iGOS BOND

YAMAKIN will respond to inquiries on the business day.
If we receive any inquiries during company holidays such as
Saturdays, Sundays, public holidays in Japan,
we will reply to you on the next day.

+81-887-55-0281

Business Hours: Weekday 8:45am to 17:45pm.

access

1090-3 Kamibun, Kagami-cho, Konan-shi, Kochi 781-5451 Japan



PAGE TOP

Sitemap

YAMAKIN > Products > iGOS BOND > Step

PAGE TOP